Mike Pike Springs

Each Spring Set includes fully punched front and rear spring.

Liner Spring Set - S&H Liner, Half Cup Liner, Mean Mugger Liner, Tea Cup Liner
Liner Medium Spring Set - Brass Jonesy Liner
Shader Long Spring Set - Tea Cup Shader
Shader Medium Spring Set - Brass Jonesy Shader.
Shader Short Spring Set - Half Cup Shader, S&H Shader
Shader Short Medium Spring Set - Mean Mugger Shader

Mike Pike x Ernie Carafa Cast Iron FRAME

Very special collaborative frame designed and cast in Iron by Mike Pike and Ernie Carafa years ago, recently found and pulled from rusty buckets, cleaned up, cnc milled with collet vises brazed in. These are very limited and once they are gone they will forever be gone. 

Frame Specs:

• Cast Iron Frame
• Raw Oiled Finish
• Brazed Collet Vise
• Forward facing wingnut that won't ride your hand or get in the way
• Welded Cast Iron Wingnut Thumbscrew Included

Typical Machine Specs:

• Typically Built as a Long Stroke Liner....can be built as a Shader or Hybrid as well
• Slow Speed with a Solid Hit
• Running 125-130 Hz Unloaded at 6.5 Volts
• Great for use with 5s to 11s

As described by Mike Pike:

”I think it was around 2003 or 2004 Ernie wanted to make up some of these cast frames he made up a drawing and a buddy of mine that worked at the foundry in downtown LA made the match plate. Ernie was a good guy, and it was kind of like a tribute to him. It literally took forever for the guy to get the frames done and then milling was going to be done by another guy that had all the Frames but ended up passing away and then I mailed some in the garage and Ernie milled some and we built them up. He wanted to make he wanted to make the castings kind of thick to where they could be mailed to take any size coil and have a lot less draft angle than the ones that he did with Paul Rogers”

Made in the USA by Mike Pike